Home
Log In
Message Boards
Search our See-Doo Board
Sea-Doo Community Pictures
Sea-Doo Models
Sea-Doo Apparel
Sea-Doo Classifieds
Sea-Doo Tech Articles
Sea-Doo Tech Specs
Sea-Doo.net FAQ's
PWC Links
Need sea-doo help?
Email Us!

LOOKING FOR A PART NUMBER? Save time by using the new BRP Part Catalogs Search

Sea-Doo Part Catalogs
Sea-Doo Part Catalogs

Sport Boats Part Catalogs
Sport Boats Part Catalogs

ATV Part Catalogs
ATV Part Catalogs

Perry Performance Group

PPG Racing

Florida Rally Series

American Watercraft Association

International Jet Sports Boating Association

Personal Watercraft Industry Association



 
   Thursday, September 09, 2010  


 Author:   Topic: 04 RXP Problems with codes and ecu follow up
 davidrxp posted: 7/26/2010 9:51:24 PM   

04 RXP Problems with codes and ecu follow up to previous post

I was right I knew it after going back over the areas the troubleshooting book lists i.e. connector pins to ECU computer and other areas I was able to think of a new test. I ran power from the fuel pump connector and then checked the connector wiring harness pins I got NO POWER. This meant to me that one of the ECU output pins was damaged. Sure enough I was right that is the problem. I had to get a magnifier and a mirror to see the burnt plastic near the pin. I ended up scraping away the burnt plastic and fixed the problem the ski works fine. However I don't trust my half ass job of fixing it the CORRECT way is to get a new wiring harness connect (B) and re wire. Does anyone on here know where I can get one of those and how you go about sticking the wire in one of these small connector pins please advise me? Also I would still like to know what the heck caused the 1 ecu output pin to melt/go bad in the 1st place. My only guess is that whatever caused it to get hot and melt is probably the same problem/related to the code p1517. I say this because I never had this problem before and now after getting that code p1517 and it trying to find the compass all of a sudden the output pin fails I don't think that is a coincidence here. I think they are related one caused/contributed to the other. Please let me know any ideas you guys have on what caused this and how I can learn to fix this (i.e. put the wire in the output pin the way it was from the factory)?

Thanks for you help in advance
Dave

 

Reply to Thread
Topic: 04 RXP Problems with codes and ecu follow up
Subject:
User Name:  You have not logged in. You will need to type your user information here.
Password: 
Enter message below (press return after each line)


want to advertise on the largest seadoo enthusiast site on the web?.. click here

Copyright © 1998 - 2008 SEA-DOO.net All Rights Reserved

Sea-doo.net is not affiliated with BRP Inc. This is a user supported information and support site for the Sea-Doo Watercraft & Sport Boats products.

SEA-DOO®, SKI-DOO®, ROTAX®, CELEBRITY® are registered
trademarks of Bombardier Inc. and/or its affiliates. GTX is a
trademark of Castrol Limited, used under license.
© 1998 Bombardier Inc. *Trademarks and ® Registered 
Trademarks of Bombardier in the U.S. Patent and Trademark Office 
and in other countries. All rights reserved.
All posts and emails to Sea-Doo.net become the property of Sea-Doo.net.
Sea-Doo.net is not responsible for inaccurate opinions and advise posted to Sea-Doo.net.